0
Respuestas

A few questions

hace 2 años actualizado por anonymous hace 2 años 1

Unfortunately, I do not get an answer to my e-mails and also not through the contact form, so I'll try again here:

Mail 18.09.18:

Hello,
I would like to continue to use the service, if you could
answer my questions asked by mail on 13.09.18. Since
my pro trial runs only until the 21st, it would be nice if you
could answer the questions until then.


Mail
13.09.18:

-------------------

Good day,

I tried a bit around and am actually satisfied, but still have
a few questions:

- How can I optimize a model without hollowing?

- Can I disable the rounding off of the model?

- Does the subscription automatically continue every month, or
do I need to turn it on again every month? If it continues
automatically, how long is the notice period?

Many Thanks

Best regards


Respuesta

Respuesta
Respuestas

Hi,

Sorry for the delayed reply, our apologies. Here are answers to your questions:


- How can I optimize a model without hollowing?
You might want to increase the close holes parameter or the clearance parameter, if your model got a hole in it then a hollow structure will be created even if you didn't requested to hollow the model, also make sure hollowing is set to zero.

- Can I disable the rounding off of the model?
Try increasing polygon reduction and Quality settings, we are going to introduce a higher quality fixer that will reduce any rounding.


Does the subscription automatically continue every month, or
do I need to turn it on again every month? If it continues
automatically, how long is the notice period?


It will automatically continue unless you cancel it.

Respuesta
Respuestas

Hi,

Sorry for the delayed reply, our apologies. Here are answers to your questions:


- How can I optimize a model without hollowing?
You might want to increase the close holes parameter or the clearance parameter, if your model got a hole in it then a hollow structure will be created even if you didn't requested to hollow the model, also make sure hollowing is set to zero.

- Can I disable the rounding off of the model?
Try increasing polygon reduction and Quality settings, we are going to introduce a higher quality fixer that will reduce any rounding.


Does the subscription automatically continue every month, or
do I need to turn it on again every month? If it continues
automatically, how long is the notice period?


It will automatically continue unless you cancel it.